Overview

In-Ceiling Back Box (Top View)

  1. Grommets

    Provide weatherproofing and protection around the cables that pass through the back box.

  2. Spring Clips

    Spring loaded clips that secure the camera to the ceiling tile.

Pendant Back Box (Top View)

  1. NPT Thread

    1 1/2-inch NPT thread included in the back box for attaching to camera mounts.

  2. Grommet

    Provides weatherproofing and protection around the cables that pass through the camera housing.

Dome Drive

  1. Tamper Resistant Screws

    Captive screws to fix the dome drive to the back box.

  2. microSD Card Slots

    Includes the pre-installed onboard storage (either one or two microSD cards, dependent on the purchased retention period).

  3. Link LED Indicator

    Amber LED indicates if there is an active connection in the Ethernet port, and that the device is receiving power.

  4. Firmware Revert Button

    Use the firmware revert button to reset the device.

  5. Connection Status LED Indicator

    Green LED provides information about device operation. For more information, see Connection Status LED Indicator.

  6. Lens

    The camera lens is housed behind a protective window.

The camera LEDs will flash and provide status information when the camera is establishing a network connection. Once the camera starts streaming video, the LEDs will automatically turn off.

Back Box (Bottom View)

  1. Ethernet port

    Connects the camera to the IP network and supplies power to the camera through the network using Power over Ethernet 802.3bt or 802.3at for indoor models only and ambient temperatures above -10°C.

  2. Audio In

    An 16-pin connector used to connect a suitble microphone to the audio in and out. Use a 24 ~ 30AWG multi conductor cable. For more information, see Connecting to Power and External Devices.

  3. Power Terminal

    The port is used to connect with a 24 VAC power supply. Use 16 to 20 AWG gage wire.

    There is no polarity for the power connection.

Camera Lower Dome

  1. Trim ring

    Protective ring attached to the lower part of the camera's dome housing.

  2. Tamper resistant screws

    Star-shaped captive screws to fix the dome cover to the base.

  3. Dome cover

    Vandal resistant dome cover.

Pendant Wall Mount

  1. 1-1/2” NPS thread mount

    Female NPS thread mount for pendant camera installations.

  2. Pendant wall mount screws

    Screws (user supplied) for securing the pendant wall mount to the mounting bracket.

  3. NPT pipe entry hole

    A 3/4” NPT threaded hole for NPT pipe conduits.

The pendant wall mount is sold separately.

NPT Mount View

  1. NPT Pipe

    NPT pipe for mounting camera.

  2. 1-1/2: NPT female to NPT-female adapter

    An adapter for attaching the pendant back box to an NPT pipe.

  3. Lock nut

    Locking nut for securing the pendant back box on the NPT-female to NPT-female adapter.

  4. Pendant mount camera

    Pendant mount camera.

The NPT pipe and the 1-1/2" NPT-female to 1-1/2" NPT-female adapter is not supplied or sold by Avigilon Alta and should be sourced separately.